Reasons for slow tapping speed of Screw tap

2025-09-01 15:21:56

1. Worn tooth tips or weak tension springs. It is necessary to check whether the tapping tips of the gear shift Hand Tapping tap are worn, resulting in uneven force distribution, and then check whether the tension spring is too loose or replaced with a new one.

2. The belt adjustment is not tight enough or the belt is damaged, causing slippage. If the triangular belt of the Hand tapping tap is too loose, adjust the adjusting screw at the back of the machine to a suitable condition or replace the belt with a new one.

3. If the belt is too loose, loosen the four small screws that secure the Hand tapping tap, then press the Hand tapping tap down and tighten the four screws.

4. The brake pedal of the clutch is poor, and the brake pads can be replaced or the Hand tapping tap can be replaced.

5. The micro switch is broken, replace it with a new one. (How to replace micro switch to be continued) Drilling Hand tapping tap

6. The orientation of the cam stop switch is incorrect. If the engine is started too slowly, it can also cause instability in the teeth of Screw tap.

7. Data deformation or excessive residue inside the clamp. You should check more information and clean the chuck more.

There are many factors that affect the tapping speed of Titanium plated tap, such as the tapping material, type, number of teeth eaten, hole shape, cutting materials, and cutting oil, etc. So when choosing a fully automatic Hand tapping tap, these factors must be taken into consideration.